Product List
PLYWOOD
FANCY PLYWOOD

Home > Products > Plywood > Core Sander

 
 
WHY DO YOU NEED THIS MACHINE

Bad quality from lathe produces uneven thickness of core veneer due to the outorn plywood.Core sander can increase the re-usable ratio of veneer.
Raising recovery from small diameter log and bad quality log.


Cost too much time in repair work of thin plywood such as overlap.
Save the usage of glue efficiently.


WBSC-1S

Special Construction

New design in sanding roller. Traditional sanding roller is perpendicular to the plywood feeding direction. It’s difficult to remove overlap and uneven thickness core problem. And often damage the core which is in bad adhesively. So we design ANGULAR SANDING ROLLER , it has 8 degree with plywood feeding direction .It will easy to sanding out overlap problem .And can save about 20% power .
Vacuum table and feeding conveyor , we make a vacuum table under sanding roller and we pierce hole in feeding conveyor .When plywood goes into sanding roller will hold by air-suction ,so plywood will flat and steady .It is especially for the thin plywood .

Special steel sanding roller with 75 HP motor , big steel sanding roller(diameter 310mm) and big power provide the best calibration function for plywood thickness control , especially for thick plywood .And good heat emission for 24 hour non-stop running .

Safety Construction :

1.The First feeding roller with one way bearing to prevent panel rebound when feeding .  

2.Safety protection design when machine in abnormal operation will auto-stop . Such as plywood too thick , sanding Amps over , sanding paper in abnormal condition….

The patented fork type pressure shoe and grooved pinch roller fully eliminate the bothersome problems of panel inserting , jamming warping during panel feeding .

 

 
WE CAN SAVE YOUR CORE PROBLEM AS FOLLOWING:

Kinife scar on core.
All can be removed!

Overlap on core.Overlap width within
1/4" all can be flat after sandind!
Rough face on core.
Can be flat after sanding.
 
Uneven thickness core veneer, From
+0.5mm ~ -0.1mm can be flat after sanding!

Specifications

WBSC-1S

WBSC-2SR

Max. workable size (W x T)

1320mm

1320 mm

Min. workable size(L)

780 mm

780 mm

Variable feeding speed

15~60 M/Min.

15~60 M/Min.

Motor for no.1 sanding head

75HP Steel roller

75HP Steel roller

Motor for no.2 sanding head

50HP Rubber roller

Reducer for feeding conveyor

7.5HP

7.5 HP

Reducer for elevation (up & down)

1HP

1HP

Motor for brushing roll

1HP

1HP

Sanding belt size

53(W) x 103(L)

53(W) x 103(L)

Custom machine specifications are available.

All specifications,dimensions and design characteristics shown in this catalog subject to change without prior notice

金瑞文機電有限公司 KING JUI WEN CO., LTD.鎮盟機械股份有限公司 GERMANE MACHINERY CO., LTD.
No.3, Kuang Ming 3rd Lane. Wei Hsin Rd., Yung An District. Kaohsiung. 828 Taiwan.
TEL:886-7-6915316 FAX:886-7-6915320
E-mail: kjw.germane@msa.hinet.net kmdd@kjw-germane.com